Ecumaster forum

Car:
BMW E35 325i (M50B25 Non vanos) N/A - Full Stock

So here is the problem, the car right now can't idle, i have to sustein the throtle at 5% so that the engine can run and yesterday at low RPM's there was a significant delay/bog between 0 to 15% TPS... I have change some parameters from yesterday, right now i can't figure whats wrong.

Please help

Thanks

Project: https://www.dropbox.com/s/yhiw2rjblmh00 ... 5.emu?dl=0
Log: https://www.dropbox.com/s/u3y7wd2efxjx0 ... mulog?dl=0

Well, nobody helped...

I managed to fix this problem by miself,

As far as i have understand the problem was in the PID settings, i have tinkered with them and manage to make the engine work again...

So right now the idle is not perfect but it works again, it wold be nice if somebody know or can write a small tutorial talking about the right settings/setup for this sort of PWM Idle Valves (3 wire no spring)?

My VE and ignition table is perfet at idle speed, but if i turn the valve on the idle starts to became instable.

All the help is welcome

https://www.dropbox.com/s/ng1tmu7zh8cdorm/3.emu?dl=0

Please send log file from idle

https://www.dropbox.com/s/xt3hayctqenkk ... mulog?dl=0

here it is