Ecumaster forum

hi

im having a strange problem
after 2 years working, now the ecu seams to reset

there is the log file on dropbox

and the config file

is a 4 cylynder wasted spark engine, itb, 36-1 ckrank

i need some help

https://www.dropbox.com/s/09lirpf0k2wti ... 1.zip?dl=0

no one can help me???

someone knows the emails of the gurus of ecumaster? the builders?

I had once a problem like that with a faulty tps shorting the 5v.

roquete wrote:I had once a problem like that with a faulty tps shorting the 5v.

im afraid of a 5v problem too,

i read your post about that.

but in this case i thing is diferent, its related with 5v circuit too, but not related with tps.

i have an oil pressure sensor, 5v / sensor ground and signal,
the wires broke with extreme heat, and touch one each other
and after that im having this problem, i dont have anymore those wires conected, but im afraid that the 5v internal circuit have this problem/is damaged.

could be possible?

regards

Would have been easier if you mentioned that from the beginning.
The only way to fix it is to send it to Ecumaster.

PSI-Motor wrote:Would have been easier if you mentioned that from the beginning.
The only way to fix it is to send it to Ecumaster.

i just have another ecu to test...

tomorrow i hope good news

We are working on new firmware that will solve problems. We found source. Until new firmware will be release, we advice to downgrade firmware to version 1.126 and lower. This should temporarily solve problem.

https://dl.dropboxusercontent.com/u/286 ... 73exp1.exe

Upgrade firmware 1.173.
New version of firmware detect revision of processor and disable function causing error