Page 1 of 1

Opel 3.2 v6 need startup map

Posted: Fri Apr 29, 2016 8:25 pm
by kadettgsi16v
Hello here on the forum...

Can anyone help me with a startup map for a opel
3.2 v6 engine stock cranksensor and wheel 60-2 with no ignition module and standard coilpack... at the moment running 2.5 intake no idle motor.. high compression pistons octane 99 fuel... if you just can help me with all the trigger info on the engine i would be very happy... kind regards René from denmark xecuter@live.dk

Re: Opel 3.2 v6 need startup map

Posted: Sat Apr 30, 2016 4:59 pm
by peder olin
Someone please help!
Desperatly need help

Re: Opel 3.2 v6 need startup map

Posted: Sat Apr 30, 2016 6:11 pm
by gregpe
peder olin wrote:Someone please help!
Desperatly need help
look like nobody done it .. or nobody want to share bur in EMU crating start map is very easy..
1 start from reading manual and help files in software.
2 connect all wires.
3 check trigger setings on scope.
4 next ignition timing lamp to find correct angle.
5 use correct setting for injector size and engine .
6 put in VE map about 40 on area of idle.
7 in engine start cranking fuelling something between 3 and 5 ms and you should get it running.

THE MOST important is first point READ MANUAL

Re: Opel 3.2 v6 need startup map

Posted: Sun May 01, 2016 4:49 pm
by peder olin
I already got the basic setting from my megasquirt.. i just got problems with both the tps,clt og iat sensors..
The tps is not showing any changes when i twist the throttle from zero to full..

Re: Opel 3.2 v6 need startup map

Posted: Mon May 02, 2016 1:11 pm
by gregpe
look like wiring problem double check wiring as you have a problems with almost all sensors check sensors ground.

Re: Opel 3.2 v6 need startup map

Posted: Wed May 04, 2016 7:33 pm
by kadettgsi16v
A base map for a c25xe or x30xe is also fine

Re: Opel 3.2 v6 need startup map

Posted: Thu May 05, 2016 4:01 pm
by Jadzwin
your tps is problably connected wrong.

Do you have IAT, CLT GM numbers ?

Re: Opel 3.2 v6 need startup map

Posted: Fri May 06, 2016 10:55 pm
by peder olin
We finally got the wiring right,the only thing left now is which injector to spray when.. i am running a wasted spark and the firingorder is 1,2,3,4,5,6.. my question is on what ign. Event the injector is ment to spray.. sorry for my stupid questions

Re: Opel 3.2 v6 need startup map

Posted: Sat May 07, 2016 7:05 pm
by kadettgsi16v
And anybody know the right trigger angle and first trigger tooth... engine almost running now... please help c25xe x25xe x30xe y32se

Re: Opel 3.2 v6 need startup map

Posted: Mon May 09, 2016 1:52 pm
by Jadzwin
Hi!

Please try to use those settings:
Image



ALWAYS CHECK THE TIMING WITH THE TIMING LAMP

Re: Opel 3.2 v6 need startup map

Posted: Mon May 09, 2016 10:55 pm
by kadettgsi16v
Thanks we will try... we dont use 2 trigger only crank trigger

Re: Opel 3.2 v6 need startup map

Posted: Tue May 10, 2016 8:39 pm
by Jadzwin
So do not forget to pair coil outputs (for wasted spark)

Re: Opel 3.2 v6 need startup map

Posted: Tue May 10, 2016 9:24 pm
by peder olin
I am using a stock coilpack from a normal opel v6 with 3 input and 6 sparkplugwires connectors.. do i still have 2 pair the outputs?
The car is cranking and moving to afterstart and then it dies again,we tried changing the fuel on every possible way but nothing give us a big change..

Re: Opel 3.2 v6 need startup map

Posted: Thu May 12, 2016 8:12 am
by kadettgsi16v
Car is running now... thought the fuel map was in milli seconds but its micro seconds so needed way more fuel...