Ecumaster forum

hey,

im searching for the right setup for the bosch sensor 0 280 130 085.
in the doc, i can find the electrical resistance at 20 °C which is 2.4 kOhm ±5.4 %.

for temp point 0 and temp point 2 in IAT-setup, i have no information about the sensor.
can anyone help? clearing the input fields is disallowed by emu

doc: here

greetings from germany

Sensor is placed in some Volkswagen around golf mk4 platform. here is the table, for someone who cant find the right setup,like me

sorry for the bad shot..

Picture

Most Bosch sensors have the same calibration or there are negligible differences just use Bosch predefined curve

ive done this before, but the output of the sensor was mostly false.

now its working fine