Ecumaster forum

Hi there,
I'm right now trying to start up my SR20DET for the first time with the EMU, but I'm not shure about how to set start parameters
I'm running:
Bosch 2x2 Wasted Spark
Jecs 755cc
My First and Second Trigger setting, as well as the ignition events are right, i double checked that.
For Crank i have 10 degrees btdc.
So i'm pretty shure it's because of the fuel. what should i apply for crank and afterstart?
Thx Thilo

Hi here is my file from my ca18det probably it will work for sr20det. unfortunately my sr20det is not finished yet from the engine shop
hope i help you
coils per cylinder

my working configuration

Hi,
thanks for the quick answer, I will try this within the next days and will let you know, if it work

Hi,
so I managed to get my engine running, after a bit of trying. Cranking fuel was way to high, now i have 3ms PW for starting at 20°C CLT. So then the engine ran a short time after start but went of again. Thanks to clem from this forum I've got an other VE table, wich was the solution for the problem. Tomorrow I will try to move the car the first time
Thanks for your help, at time when my map got better, I'll post it here for other users
Greets Thilo