Ecumaster forum •Innovate MTX-L to EMU

Page 1 of 1

Re: Innovate MTX-L to EMU

Posted: Wed Sep 09, 2015 12:00 pm

by PSI-Motor

Silas wrote:Hi

I already have a Inno Wideband Controller installed.
Back of the Gauge there are two Datalog Wires (0V-5V) and (1.1V - .1V)

So should i connect the yellow wire of the Innovate (0-5V) direkt to any Analog Input of the EMU?

So i dont Need to connect the lsu4.2 direct to the EMU?

Regards
Patrick

Use yellow wire

Re: Innovate MTX-L to EMU

Posted: Thu Sep 10, 2015 1:19 am

by Jadzwin

Any free one. In Oxygen sensor parameters you can select analog input.

Re: Innovate MTX-L to EMU

Posted: Thu Sep 10, 2015 1:14 pm

by ktsirigotakis

you have to set also the parameters to work correct see the pic of a friends cars