Ecumaster forum

Hi all

I have attempted to start my car for the first time today since fitting the EMU. The car will not start, just cranks over. I have selected 'Enable Scope' in the 'Ignition - Primary Trigger' menu and opened the Scope in the Log menu but nothing shows up whilst cranking, it stays empty . I have looked at the Ignition Log and this is what I see whilst cranking ...



It says the ignition is synchronised but yet I cannot see anything on the scope ... any ideas why this is happening?

Thanks in advance

Press "get scope data" while you crank

Thanks for the info, that did the trick . I was pressing 'Get scope data' before i cranked and it wasn't getting logged

What does Scope do for you? just to see if you see crank signal? please explain.. greatly appreciated.

Yes, it shows a signal from the crank and cam triggers, helps you iron out any syncing problems