Ecumaster forum

Posted: **Tue Jun 21, 2016 5:18 pm**

hi

im intaling an EMU and building a new wiring loom on this engine
its a 2JZ-Gt
for now i have some questions...

on the cam, have 2 vr sensors for cam position, wath is the sensor that i need to use? the sensor on the middle of the head, or the sensor on the back of the head?
what is the configurations for the pimary and secondary trigger?
someone have a start up file?

and finaly

is the stock knock sensors compatible with the EMU.
if not
what sensor can i use?

regards

Posted: **Wed Jun 22, 2016 8:05 am**

I used cam sensor on the back of the head.

Posted: **Wed Jun 22, 2016 8:11 am**

tonas wrote:I used cam sensor on the back of the head.

ok thanks

it is possible to send just a picture of the primary and secondary trigger setup?

Posted: **Wed Jun 22, 2016 9:13 am**

It doesn't matter which sensor on head You will use. EMU use only one for synchronization. Personally i'm using G1 in the middle on the head.

Posted: **Wed Jun 22, 2016 10:34 am**

Kisielisodd wrote:It doesn't matter which sensor on head You will use. EMU use only one for synchronization. Personally i'm using G1 in the middle on the head.

now im confused...

Posted: **Wed Jun 22, 2016 11:27 pm**

Kisielisodd wrote:It doesn't matter which sensor on head You will use. EMU use only one for synchronization. Personally i'm using G1 in the middle on the head.

what is the firing order of that? can you post some screen shots?

Ecumaster forum

Toyota supra 2jz-gt non vti trigger and knock

Toyota supra 2jz-gt non vti trigger and knock

Re: Toyota supra 2jz-gt non vti trigger and knock

Re: Toyota supra 2jz-gt non vti trigger and knock

Re: Toyota supra 2jz-gt non vti trigger and knock

Re: Toyota supra 2jz-gt non vti trigger and knock

Re: Toyota supra 2jz-gt non vti trigger and knock