Page 1 of 1
how to connect the triggers to the audi 5 cyl(3B,AAN)??
Posted: Sat Jul 09, 2016 11:07 am
by gesch
CRANK SENSOR (135 teeth ) need to be connected to primary trigger
CRANK SENSOR (1 tooth) - need to be connected to CAM #1 (with 1K5 pulldown )
CAM SENSOR HALL - need to be connected to CAM #2
with 1K5 pulldown,where to solder??
Re: how to connect the triggers to the audi 5 cyl(3B,AAN)??
Posted: Sun Jul 10, 2016 9:15 am
by Karel
On 5 cilinder you must know the TDC on working cycle for the 1st cilinder if you will use individual coils. (It wil be used as secondary trigger so CAM 1)
1k5 ?
pulldown always means connecting between sensor signal and sensor ground to lower the voltage, and noise also.
Re: how to connect the triggers to the audi 5 cyl(3B,AAN)??
Posted: Mon Jul 11, 2016 11:37 am
by gesch
Karel wrote:On 5 cilinder you must know the TDC on working cycle for the 1st cilinder if you will use individual coils. (It wil be used as secondary trigger so CAM 1)
1k5 ?
pulldown always means connecting between sensor signal and sensor ground to lower the voltage, and noise also.
thank you
Re: how to connect the triggers to the audi 5 cyl(3B,AAN)??
Posted: Mon Jul 11, 2016 11:37 am
by gesch
Karel wrote:On 5 cilinder you must know the TDC on working cycle for the 1st cilinder if you will use individual coils. (It wil be used as secondary trigger so CAM 1)
1k5 ?
pulldown always means connecting between sensor signal and sensor ground to lower the voltage, and noise also.
thank you