Ecumaster forum

Hi,

My standalone arrived
And i'm not sure if the ECU MASTER will work with the Bosch LSU 4.9? I'm planning to buy a PLX Wideband with external controller and gauge --> http://www.ebay.co.uk/itm/121434697332? ... EBIDX%3AIT

and i'm not sure if this is compatible with the EMU... Can I buy this item, or should I order the LSU 4.2?

Thx mates

DaRK wrote:Hi,

My standalone arrived
And i'm not sure if the ECU MASTER will work with the Bosch LSU 4.9? I'm planning to buy a PLX Wideband with external controller and gauge --> http://www.ebay.co.uk/itm/121434697332? ... EBIDX%3AIT

and i'm not sure if this is compatible with the EMU... Can I buy this item, or should I order the LSU 4.2?

Thx mates

If your intentions are to run the wideband sensor directly to the EMU you need to use the 4.2, but if you are using external controller and sending a 0-5v signal in to one of your spare analog inputs it doesn't matter if the controller is using 4.2 or 4.9.

Hi psi-motor

Thanks for your quick reply mate.

Yes, i'm going to use an external controler.


thx again