Page 1 of 1
launch control
Posted: Sat Nov 19, 2016 10:38 am
by fred64480
hello , How to connect launch control ??
Re: launch control
Posted: Sat Nov 19, 2016 5:37 pm
by PSI-Motor
fred64480 wrote:hello , How to connect launch control ??
Read help files in the software or look in the manual.
Re: launch control
Posted: Sat Nov 19, 2016 8:15 pm
by fred64480
Sorry but I can not find
Re: launch control
Posted: Sat Nov 19, 2016 8:34 pm
by PSI-Motor
5v to a button, from button to a analog input.
If you go to launchcontrol in the software and press F1 you will get a pop up help
Re: launch control
Posted: Sat Nov 19, 2016 11:08 pm
by fred64480
ok thank you , Sorry for English because I am French
Re: launch control
Posted: Sat Nov 19, 2016 11:12 pm
by fred64480
Well, I found everything thanks to you but I can not connect to analog # 2 because dbw analog # 1 and # 4
Re: launch control
Posted: Sun Nov 20, 2016 12:40 am
by nickbmw
Or just set it to always on and set the conditions.
Re: launch control
Posted: Sun Nov 20, 2016 1:18 am
by PSI-Motor
Or cam input 2
Re: launch control
Posted: Sun Nov 20, 2016 9:09 am
by fred64480
So to validate my editing it is output 5volt has my button and back on an analog output and I put a resistance of 2k2 to ground or no need. I can not put in cam # 2 because I have two camshaft sensors. Engine golf r32