The ecu tuner3 not turn on

DET3 technical support
Locked
voodoo
Posts:5
Joined:Tue Jun 16, 2015 5:22 am
The ecu tuner3 not turn on

Post by voodoo » Tue Jun 16, 2015 5:40 am

Hello everyone.I have problems with DET3 Iconnected the unit to Toyota 1jzgt . the unit it does not turn on :geek: . I following the digram and connect all wire. But do not result. I need help. :geek:
Top
MJG
Posts:11
Joined:Thu May 28, 2015 3:36 am

Re: The ecu tuner3 not turn on

Post by MJG » Tue Jun 16, 2015 4:47 pm

It should turn on with pin 1 at 12v and pin 11 at earth. If not, it must be broken! Did you crimp and solder the pins well, and have they engaged fully on the DET3? I found that my 12v pin poked back out of the plug initially, so I had to wedge it back in. The pins and plug are only a low quality/cheap item so take a bit of fiddling.
Top
voodoo
Posts:5
Joined:Tue Jun 16, 2015 5:22 am

Re: The ecu tuner3 not turn on

Post by voodoo » Thu Jun 25, 2015 3:30 am

thank you very much .now the unit is working. :D I found the problem @ I fixed it.
Top
voodoo
Posts:5
Joined:Tue Jun 16, 2015 5:22 am

Re: The ecu tuner3 not turn on

Post by voodoo » Thu Jun 25, 2015 3:40 am

I want to ask you about the uint. Do device can control the rpm revolution and limiter to give very hard cut .like BAAAAANG BAAAAG. 8-)
Top
mihaicsv
Posts:25
Joined:Thu Apr 30, 2015 5:13 pm

Re: The ecu tuner3 not turn on

Post by mihaicsv » Fri Aug 28, 2015 10:06 am

You mean launch control ? They say it can,never tried it myself.It's all in the user manual.If you try it keep up posted :)
Top
Locked

Return to “DIGITAL ECU TUNER 3”