Subaru trigger support.

[dragster]

I hope that Subaru/rx7/rx8 trigger can be supported.
it is using 36-2-2-2 trigger pattern with 8500 rpm limit.

[Jadzwin]

We have lots of request for this trigger type, so we decided to add it to the DET3.
It should be available in about one week.

[dragster]

that will be great. happy to hear that.

[dragster]

We have lots of request for this trigger type, so we decided to add it to the DET3.
It should be available in about one week.

Any development on this yet?

[Jadzwin]

Hi!

In the latest software we have added subaru 36-2-2-2 trigger.
Already it was tested on simulator and seems to work.

[dragster]

great news. i will give it a try.

[dragster]

I just tested the new firmware (1.30) with 36-2-2-2 trigger pattern. Sadly to let you know that the engine failed to start with it. I can't test with DET3 FI because the trigger pattern is not found in it.
Anything that I can do to help?

[dragster]

i scoped the input vs output through DET3 and i found that there are no waveform at the output hence the no start condition.

[Jadzwin]

Try to use 1K pullup to +5V or pulldown to the ground.

[dragster]

I reflashed the firmware and using 5V pullup, I manage to get the engine running.
Now, using DET3,the engine only manage to rev till around 4500rpm and it behave as if
it is having the launch control set on.