Ecumaster forum

Hi, is there anyone here has succeded create injector emulation so the mil dash are off. The injector on my bike were 13.8 ohm.
I use resistor 15w 4,7 from det3 to injector with bank mode. The run well & smooth with FIT, just anoying with mil dash always on.

Hi,

just hook up 14Ohm resistors to original ecu 5Watt .

or reprogramm original ecu for DTC off ....

what bike is it ?

Thx for the answer, but my det3 has been sold. And statisfied for the result, but to work all det3 feature need to pull out map sensor and induction system, don't wanna mess with that, anyway my bike were benelli tnt250/300.