Strangely, my AFM signal outputs 5V when it’s closed, and 0V when it’s open. Backwards from most. The sensor input on the fuel table reads 0-5V, and this makes it very difficult to manage with my AFM signal output. Is there a way to rewrite the liner sensor definition file to account for a 5V to 0V (decreasing), rather than a 0-5V (increasing) response? I looked at the text in the definition file, but I’m not familiar with the basic language this file type uses. Anybody know how I might rewrite it to account for decreasing linear voltage Berwyn 5-0V?
Thanks!!!