Ecumaster forum

Hello guys,
I have a problem with my Det 3 in my 98' NB 1.6 Miata.
I connected the crank(ignition) senzor, the maf(analog 1), and the MAP(included) right after the throttle body, to the det3 and their output to the ecu.
The RPM output it higher than my cars tach (+800 ~ RPM).
And if i accelerate the line (in the table) only goes up and down and not right or left.
I don't know if the fuel map even works... ?
Any ideas ? Thank you!
The scheme i used and the video:
https://drive.google.com/open?id=1NUy0V ... 3Ayc9KsC7A
https://drive.google.com/open?id=1uK0Sd ... foGDZweSfN

Wouldn't you need the TPS wired in too?

mccolome wrote: ↑

Fri Jan 04, 2019 9:15 pm

Wouldn't you need the TPS wired in too?

no, i found out that Nb crank angle sensor is different as NA, so... not nice as the output is different, i will try hooking up to the ignition module, but i don't know how exactly