Page 1 of 1
rezistance box for low impirance injectors help
Posted: Tue Dec 09, 2014 1:58 am
by ktsirigotakis
Hi to all
today i was traying to put some rezistors to my injectors due to they are low z 2Ω so i boght 4 8Ω 15w rezistors and i put them i series to the injectors line power 1 two rezistors and power 2 the other two. The car wont stat them removed th and the car was working i put one and and again nothing. So the car is working with total rezistance 4Ω per power out and i am in danger to burn my power out puts. Please advice me what to do with my problem?
Car: s13 200sx ca18det
Det3 400kpa fit mode
Thanks in advance
Re: rezistance box for low impirance injectors help
Posted: Tue Dec 09, 2014 2:05 am
by Jadzwin
Try just conect two injectors in series. The resistance will be 4 Ohm and it should work using 2 banks.
If you want use resistor to limit current use 3R3 or 4R7 per injector.
Re: rezistance box for low impirance injectors help
Posted: Tue Dec 09, 2014 2:26 am
by eugen_troll
Nissan s13 ca18det have alredy resistor box.
see small box on airfilter under afm.
Re: rezistance box for low impirance injectors help
Posted: Tue Dec 09, 2014 11:14 am
by ktsirigotakis
According to my measurments i have 4.4r per bank so if its ok i will leave it as it is. I have some wiring problems due to the age of the car if start spending to much time on i will spend time for new wiring with emu and problems will be solved
Oooo i didn't know that was a resistor box i have move it on the other side because i removed the afm and everything that they were there and i cut the afm wire
I have some problems with the clt i cant calibrate it!!!! Det3 goes out of limits
Thanks for you help