Page 1 of 1
Subaru trigger support.
Posted: Tue Aug 19, 2014 3:38 pm
by dragster
I hope that Subaru/rx7/rx8 trigger can be supported.
it is using 36-2-2-2 trigger pattern with 8500 rpm limit.
Re: Subaru trigger support.
Posted: Tue Aug 19, 2014 4:06 pm
by Jadzwin
We have lots of request for this trigger type, so we decided to add it to the DET3.
It should be available in about one week.
Re: Subaru trigger support.
Posted: Tue Aug 19, 2014 4:10 pm
by dragster
that will be great. happy to hear that.
Re: Subaru trigger support.
Posted: Tue Sep 23, 2014 6:56 am
by dragster
Jadzwin wrote:We have lots of request for this trigger type, so we decided to add it to the DET3.
It should be available in about one week.
Any development on this yet?
Re: Subaru trigger support.
Posted: Sun Oct 12, 2014 12:48 am
by Jadzwin
Hi!
In the latest software we have added subaru 36-2-2-2 trigger.
Already it was tested on simulator and seems to work.
Re: Subaru trigger support.
Posted: Mon Oct 13, 2014 4:50 pm
by dragster
great news. i will give it a try.
Re: Subaru trigger support.
Posted: Fri Oct 17, 2014 6:22 pm
by dragster
I just tested the new firmware (1.30) with 36-2-2-2 trigger pattern. Sadly to let you know that the engine failed to start with it. I can't test with DET3 FI because the trigger pattern is not found in it.
Anything that I can do to help?
Re: Subaru trigger support.
Posted: Mon Oct 20, 2014 6:12 am
by dragster
i scoped the input vs output through DET3 and i found that there are no waveform at the output hence the no start condition.
Re: Subaru trigger support.
Posted: Mon Oct 20, 2014 2:56 pm
by Jadzwin
Try to use 1K pullup to +5V or pulldown to the ground.
Re: Subaru trigger support.
Posted: Thu Oct 30, 2014 9:37 am
by dragster
I reflashed the firmware and using 5V pullup, I manage to get the engine running.
Now, using DET3,the engine only manage to rev till around 4500rpm and it behave as if
it is having the launch control set on.