Ecumaster forum

I have setup launch control to activate using Input 4. I am getting a clean 4.96v when switch is active. Launch control is not activating?
I can see the voltage in the client window and have triple checked my settings. Launch control works when set to always active but thats it.

Am i doing something wrong?

I have just found the 1.32 Firmware for the DET3 client so i will try again with that tomorrow..

its better to use ground than 5v the only thing you have to do extra is to select the box that says inverted
analog 4---switch----ground

Ill give that a go in the morning! thanks

That doesnt work.. the analogue input is always 0v so, putting a switch to ground does nothing. The launch control stays on constant when i do it this way as inverted sets it to come on when input is lower than 4.8v which it is always..

I originally had:
An4 - switch - 5v

Now i have

An4 - switch - Grnd

I see the frequency input uses pullup somehow but i cant read the rest of the text on the option.. very frustrating as it doesnt work as it should. It should work with the 5v input.

So i had to learn how pullup resistors work when grounding a freq input. have launch control working now

the best thing you have done i was in harry and didn't explained it to you that day

hi. can you tell me how you have done?