hey guys
im new to this mapping and piggy backing
I have successfully installed the det3 device on my z3 with a m50 2.5 non vanos turbo and updated the firmware to run in fuel implant mode
now im stuck what to do , I don't know what the parameters should be on the map sensor I don't no how to map , basically I know nothing lol
would anyone be able to help me get a decent safe base map running on it so I can take it to a professional
mods on the car are
t04 turbo
rising rate fpr
2.8 pink injectors
mls head gasket
huge intercooler
car ran fine before installing the piggy back but seemed to have white plugs even though the wideband was reading around 11.1 on WOT I did have a 700ohms resistor to trick the hotwire maf into taking the boost on the input wire