Ecumaster forum

Hi!!!!
I have a big problem! my det 3 has always had some problems and every time I connect the PC and load map from the control values of the scales are the basic preset !!! when loading the map from the control unit and then edit ..... save everything .... and when reloading the map I have all the values at zero !!!! as it was the first starter !!!! time ago it happened sometimes that I saved the map is altered values of the stairs in an exaggerated ..... for example: correction with pressure 1 bar .... 60% correction with 1.1 bar 5555% !!! !! or 9999 !!!!
Some Bug ?! Unit fails ?! I do not know what to do..
Please help me!!!!!!!!!

F10 - make map permanent are you clicking this once you finished your mapping?

Yes!!!
Today I took the older maps and I loaded and remain in memory, I do not know what to do! the car goes wrong and remains lean as if DET3 not command the additional injector, the car slows down and turns bad even at idle ....
I am convinced that the problem is the DET3 because sometimes good enough and when the turbo work is rich .... sometimes it goes right !!!!

Hi, any update over this issue, cuz I think am facing something similar as well!!

Thanks,

Hello, I found a loose contact on the switch of the map, once settled this the memory is no longer missing.
I still have some problems sometimes but I live there !!!!!