Ecumaster forum

Posted: **Mon May 16, 2016 1:19 pm**

Ok i managed to start the engine in piggyback mode (USDM 2JZ GTE with maf sensor)

So my next to do thing is to get running in FIT mode. Has some did it before? Can some tell me the Setup in the Client to get it running?

The wiring is done ( a GM style iat sensor is installed, all sensor are calibrated)

Posted: **Mon May 16, 2016 1:24 pm**

At this moment iam reading again the FIT manual.

If i understood right i cant connect my 6 low impedance injectors in Batch mode?

Posted: **Wed Jun 22, 2016 11:38 pm**

german02 wrote:At this moment iam reading again the FIT manual.

If i understood right i cant connect my 6 low impedance injectors in Batch mode?

Why would you downgrade from sequential to batch!!???? Help me understand what you are trying to do?

Posted: **Thu Jun 23, 2016 10:27 am**

FIT mode works for 4 piston engines.To control the injectors you need to modify the MAF signal with the DET3.

Ecumaster forum

USDM Supra 2jz gte in FIT mode set up!

USDM Supra 2jz gte in FIT mode set up!

Re: USDM Supra 2jz gte in FIT mode set up!

Re: USDM Supra 2jz gte in FIT mode set up!

Re: USDM Supra 2jz gte in FIT mode set up!