Rx7 13b Single turbo with DET3
Posted: Mon Jul 25, 2016 10:35 pm
Can someone explain me what should I do to realize the single turbo conversion?
- Can I just rewire a MAC solenoide to control just 1 turbo?
- Will afr change if I make the conversion?
- Its supposed that the 13b use MAF, can I eliminate it? Or I need to control it?
- Is DET3 capable to support the 13b wankel engine from a fd3s?
- Is there any wiring diagram?
- Someone told me that the MAP will make not read more than 15psi. Internal map of det3 help on this situation?
Hope that some one couls help me, cheers guys!
- Can I just rewire a MAC solenoide to control just 1 turbo?
- Will afr change if I make the conversion?
- Its supposed that the 13b use MAF, can I eliminate it? Or I need to control it?
- Is DET3 capable to support the 13b wankel engine from a fd3s?
- Is there any wiring diagram?
- Someone told me that the MAP will make not read more than 15psi. Internal map of det3 help on this situation?
Hope that some one couls help me, cheers guys!