Page 1 of 1
No signal on Input #2
Posted: Thu Aug 11, 2016 7:01 pm
by spddm0n
I read today that this Input is the input tied directly to the MAP sensor (on-board). If I'm getting no signal on that input (flat-line) on the log files (real time and those that are saved), could that mean the sensor is not working?
Re: No signal on Input #2
Posted: Thu Aug 11, 2016 9:54 pm
by Koop
Which mapsensor is/should be fitted to your DET? They come in 250kpa and 400kpa. And also a variant without MAP.
Re: No signal on Input #2
Posted: Thu Aug 11, 2016 10:44 pm
by spddm0n
Hi -
I have the 4 bar unit (I think). Not sure how to tell actually. The box doesn't say either. I have a barbed nipple on the end of the unit.
Re: No signal on Input #2
Posted: Fri Aug 12, 2016 2:09 pm
by Koop
Barbed nipple is a 400kpa unit.