Ecumaster forum

Hi,

On the models with internal map sensor, how do you configure the table setup to set it as load?

The instructions cover using the analog inputs and configuring them so I understand how to use external sensors etc, but I am unsure on how the internal map sensor relates to this?

Cheers

setup -> scales configuration -> load ..

Map sensor (both 250kpa and 400kpa) are permanently connected inside DET3 to analog in#2. When You open files with load button, You will have scales files for 250 kpa map nad 400 kpa map

Kisielisodd wrote:setup -> scales configuration -> load ..

Map sensor (both 250kpa and 400kpa) are permanently connected inside DET3 to analog in#2. When You open files with load button, You will have scales files for 250 kpa map nad 400 kpa map

Ah, great info, thankyou! do I still need to earth out the analog in#2 or just leave the pin open, connected to nothing?


Gutted I didnt know this last night as I wired it in as follows ..... guess I can just swap pin "analog in #2" with "analog input #3" on the wiring connector?


Wiring configuration:

Analog in #1 - AFM
Analog in #2 - Wideband lambda
Analog in #3 - Earth
Analog in #4 - Earth


Scales configuration:

Analog in #1 - 0-5v linear scale (AFM)
Analog in #2 - Wideband lambda sensor 10-20
Analog in #3 - DET 3 with internal 400kpa map sensor
Analog in #4 - GM temp sensor (Not fitted yet which is why wiring is earth)

Thanks again!

You cant connect anything else in pin 14 (analog #2), because there is map sensor signal, just plug in inside. Just leave it empty.

WBO connect to analog #1,#3,#4

Kisielisodd wrote:You cant connect anything else in pin 14 (analog #2), because there is map sensor signal, just plug in inside. Just leave it empty.

WBO connect to analog #1,#3,#4

Perfect, thanks

Got it running tonight

Road mapping tomorrow...

Post some numbers when you´re done.