Celica ST205 Gt Four

[astra vxr]

pipe work problem then

[pepifebles]

pipe work problem then

yes. Could I take oem map hose? Oem will be disconnected.

[Jadzwin]

Yes it will work ok

[Jadzwin]

Your car the should work as factory one

[pepifebles]

Solved. New hose directly to intake manifold and run perfect.

In the other hand, when I received maps by mail to my mapper. How to write it in the ecu?

[Jadzwin]

You just need to use option Load project and then makes map permanent (F2 key).

However remote mapping is not the best solution

[pepifebles]

Its the only one solution possible for me.

Then, engine start or ignition on? Open project and F2

[astra vxr]

i would have used the base map you have ( it dont look to bad ) and map from there even if you have a map sent to you it could be still off and still need mapping as no 2 engines are the same but each to there own

[pepifebles]

i would have used the base map you have ( it dont look to bad ) and map from there even if you have a map sent to you it could be still off and still need mapping as no 2 engines are the same but each to there own

Yes, mapper have used base map and on this have change parameters. He sends me modified maps and I run it, log and tell him my impressions. Isnt easy but its possible

[pepifebles]

My Engine originally runs watercooler. Watercooler Pump is controlled to oem ECU, and now I think that emu dont controller Good. Easy to see high IAT tenperature. There is Any option to run watercooler Pump with my new emu.

Regards

[Jan32]

If everything is right connected and you use the base map from Kuba for your engine, then the water pump is activated everxtime when the motor runs. Look at Parameter output 3 at the settings there is the output activated when rpm is higher than 600 rpm.

[pepifebles]

hi guys,
after three months of hard work, today I was able to dust off my car and continue configuration of my Emu Ecu . It is impossible to run well, I must have a problem with the map sensor because the idling its unstable, at iddle when I acceleratethe engine stop, just blowing 0.7 bar ( wastegaste pressure ), the mixture is very lean (1.25 to idle). This problem occur's with all maps (base map and other 2 maps).

Does anyone have any idea what happens ?

When I load base map, This error occurs, and when load my maps, this message it´s too much longer

[pepifebles]

upload video to show my problems

View My Video

[Jadzwin]

Ignore this message. It is just warning. Different software versions have different tables / parameters.

[pepifebles]

Hi,

I reconnected the original ECU and the engine run fine, perfect. I connect the emu as I ever have all kinds of failures ( video above ) . Could this be mapping problem?

Regards

[Jadzwin]

Send the log file. We will see what is going on. Should work normally if everything is ok

[pepifebles]

How to rec log file? Only know see it.

[Jadzwin]

Just press disc icon on the log window toolbar. The file will contain all channels so just press the icon.

[pepifebles]

Finally all runs ok but I dont get boost. I upload my log and my map