Ecumaster forum

This car was my first steps on tuning cars. I started with ECUMASTER products and I don't care abut other engine management systems

so

my friend dinos has a Toyota starlet gt turbo ep82

Engine: 4efte ep82
forged pistons wossner std
forged rods
std head gasket
std head bolts (didn't know that when I was turning up the boost!!!)
4 pucks clutch
TRD ignition leads
440cc fuel injectors (impreza light blue)
255 fuel pump
IHI Vf34 (some damage was on the turbine side)
external wastegate 38mm emusa
60mm exhaust single tube at the front bumper
shorted transmission ratios
Ecumaster Det3 400kpa
1.5bar 319hp
engine was bought used and we opened the engine to put arp head studs, metallic head gasket, port and polish and we found out that the engine had cr 7.3:1 now we are closing the engine with aprox. cr 7.8 :1 also my friend bought a used very good condition Vf34.

Nice killer Many people on the road must be surprised...

ktsirigotakis wrote:This car was my first steps on tuning cars. I started with ECUMASTER products and I don't care abut other engine management systems

so

my friend dinos has a Toyota starlet gt turbo ep82

Engine: 4efte ep82
forged pistons wossner std
forged rods
std head gasket
std head bolts (didn't know that when I was turning up the boost!!!)
4 pucks clutch
TRD ignition leads
440cc fuel injectors (impreza light blue)
255 fuel pump
IHI Vf34 (some damage was on the turbine side)
external wastegate 38mm emusa
60mm exhaust single tube at the front bumper
shorted transmission ratios
Ecumaster Det3 400kpa
1.5bar 319hp

IMG_1081.JPG

IMG_1157.JPG

IMG_1086.JPG

engine was bought used and we opened the engine to put arp head studs, metallic head gasket, port and polish and we found out that the engine had cr 7.3:1 now we are closing the engine with aprox. cr 7.8 :1 also my friend bought a used very good condition Vf34.

nice

This is nice...we made the same whp on pump similar forged setup but 9.0:1cr, GT35 turbo, 50 Shot Nitrous and 23psi on Megasquirt 1; 3.7 ratio GearBox. Went up to 370whp on MS109 Race Gas, but I much prefer your power on boost only. I do have the DET3 4 Bar as well been wanting to experiment on a stock 4efte; can you share with me the Distributer wiring and ignition settings you are running?

Addi
ramsarupe@gmail.com