Ecumaster forum

hey guys, few pics from my build of my car, it has been running a 1jz gte with holset and greddy emanage for 2 years now, I've decided to fully rebuild a 2jz block with a big port 1j head and cams, then use a new turbo and emu stand alone for a bit more fun

car was completely stock when I bought it and I've done a full shell rebuild from ground up

looking for a base map for my ecu as my supplier is being a bit off with sending me a base map for some reason, it's a 1.5jz, 264* cams, 800cc sard side feed injectors and either bosch audi coil packs or bosch fiat pencil coil packs


thanks



bosch knock sensor, I was told by my supplier I cannot use the stock Toyota one, I was also told only to use one of these. shouldn't I have two as the factory Toyota setup has two?


Bluetooth sensor


oil temp sensor, does it matter which wire the resistor goes into? I have not read the instructions yet





oil pressure sensor





air temp sensor I was told to buy, unsure on make








new engine gasket set


oil and water pumps, belts and tensioners etc


all new engine sensors (bar the ones from emu)


piston oil jets





brian crower head parts


new clutch kit for bmw conversion


the car:





current engine:

Looks good, have you another forum you are posting you build on? I know this one is a bit dead