Ecumaster forum

Right, its a miracle. Ive actually made some progress on my car. and decided to post up a thread here.

Got all of my turbo setup made, ceramic coated and fitted, a bit of wiring for some new sensors and a couple of hours of mapping later and we are 417bhp.

Had to limit it to 1.2bar of boost as my fuel system is maxed out (uprated intank pump, but only using the stock reg, returnless and not rising rate with 750cc injectors)

will be good for when i go to the ring next weekend, feels fast on the road, and no where near as strangled at the top end of the revs.

Here is some media to support the above statements.

and some other pics from the past

tidy that .

dont be too long at the ring i need mine remapping

dont forget the ring video's !

hi! Can I ask you what ignition settings u've used? I connected the CKP sensor wire to Ignition in with pull and ignition out to the CKP input in the ecu. Doesnt work!
Works fine with the stock wiring back again.

Hello Sam,
I'm new here, have just ordered an EMU , please can you share your project file with me, I can't get my head around the camshaft sensor and VTEC/VTC
settings, maybe if I see them I will understand.

Thanks in advance,

Dave.