Hi
I have C revision of black from Karel and would like to confirm my pinout before doing some changes.
I would like to confirm that in my revision
- there are flyback diodes on AUX1 a AUX2
- there is no AUX4 pullup to 12V
- there is no CAN BUS terminator (which has been added in rev. D?)
and most importantly, i dont know whats on pin B38, since sensor ground has been added there in revision D
thanks
hIGGI
Emu Black hardware revisison clear up
-
- Posts:121
- Joined:Sat Aug 16, 2014 7:05 am
- Location:Finland
- Contact:
Re: Emu Black hardware revisison clear up
In revision C
- there are flyback diodes on AUX1 and AUX2
- there is no AUX4 pullup to 12V
- there is no CAN BUS terminator
- pin B38 is not sensor ground, do not connect.
- there are flyback diodes on AUX1 and AUX2
- there is no AUX4 pullup to 12V
- there is no CAN BUS terminator
- pin B38 is not sensor ground, do not connect.
Re: Emu Black hardware revisison clear up
so, there is nothing on B38 pin at all?