Page 1 of 1
Bluetooth Adapter on EMU Black
Posted: Thu Sep 21, 2017 11:35 pm
by ATS_Scott
I'm wiring in a serial port for the Bluetooth adapter (not DL-1). The BT adapter needs 3.3V, and the only output on the black is 5v. Is this "safe" for the BT module, or do I need to lower voltage to 3.3V?
Re: Bluetooth Adapter on EMU Black
Posted: Fri Sep 22, 2017 2:05 pm
by PSI-Motor
Use CAN BT.
Re: Bluetooth Adapter on EMU Black
Posted: Fri Sep 22, 2017 8:35 pm
by RasPL
Use 10ohm resistor. Check how to connect yours
bt module with arduino (atmega328) and do the same.