Ecumaster forum

I am very interested in the BLACK, Do you guys have a pin out for the 2jzgte to black available?

It would be the exact same channel assignments as the EMU, with the exception of the added constant 12V wire. That and if the signal from the A/C amp is a low side trigger, you can wire that to one of the switch inputs instead of having to use an analog input with a pullup.

WHPZach wrote:It would be the exact same channel assignments as the EMU, with the exception of the added constant 12V wire. That and if the signal from the A/C amp is a low side trigger, you can wire that to one of the switch inputs instead of having to use an analog input with a pullup.

can 'constant 12V' channel be used as a Vref for a sensor instead of 5V?

constant 12volt is from batery to ecu its mentioned to power ecu if engine is not running to avoid uncontrolled status of outputs during processor boot-up.

NOT to feed sensors or whatever else

0martin0 wrote:constant 12volt is from batery to ecu its mentioned to power ecu if engine is not running to avoid uncontrolled status of outputs during processor boot-up.

NOT to feed sensors or whatever else

thanks