Page 1 of 1
.emu files
Posted: Sat Nov 26, 2016 9:59 pm
by alper
I imported a e.mu file and the car doesnt start EVEN all the necessary settings (fuel settings, tables, ignition settings, enrichment settings) are COMPLETELY imported fine.
the only problem with this is fuel is not enough. when I increase the fuel by around %30 - the car runs fine. but the upper parts of the table are incredibly rich.
so : should the car be re-tuned ? I checked all the settings about the fuel - all are the same.
Re: .emu files
Posted: Sat Nov 26, 2016 10:05 pm
by Karel
may be, you have just wrong setting for injector death time
Re: .emu files
Posted: Sat Nov 26, 2016 10:26 pm
by alper
it is imported %100 correct.
tested.
Re: .emu files
Posted: Sat Nov 26, 2016 11:35 pm
by Karel
"Imported" from what to what ?
Re: .emu files
Posted: Sun Nov 27, 2016 12:22 am
by alper
of course from emu to emu black
Re: .emu files
Posted: Sun Nov 27, 2016 1:31 am
by PSI-Motor
BLACK uses advanced lambda VE calculation and you need to reset your Afr/lambda target.
Re: .emu files
Posted: Sun Nov 27, 2016 8:29 am
by alper
although i dont use ego feedback ?
Re: .emu files
Posted: Sun Nov 27, 2016 10:31 am
by Karel
Yes, it uses the lambda target table for the calculation.
Lest say your VE will be 100% at 10ms injection. If you put lambda 1 it will stay at 10ms and hold mixture at Lambda 1. If you select lambda 0,8 it will add more fuel to achieve your goal.
Re: .emu files
Posted: Sun Nov 27, 2016 6:34 pm
by PSI-Motor
alper wrote:although i dont use ego feedback ?
Of course, its like all ecu:s with "true" VE calculation.....