Ecumaster forum

Hi

With Karel we have wired EMU Black to my rotary powered RX8, running with 0 split so far.
DBW works
CAN gauges works
Electric PowerSteering seems to work ok too

however , i have ABS and TCS light on and no speed info on gauges
In Sensor setup, i tried pretty much anything, as speed source i have CAN wheel speed and in log (VSS and gears) i have working wheel speed sensors (value is changing when car is moving), but no changes to Vehicle speed.

Any ideas?

thanks

hIGGI

Do you have any tool to scan CAN BUS ?

i am away, will try autocom scantool when i get back

EMU black now on 2.046 firmware, still no ABS and TCS

Speed in EMU software and on gauge cluster works, powersteering seems to be working too.

ABS unit error codes :
C1805
AND
U1900

Hi, I also have an RX8 and have the Ecumaster EMU (not Black) on firmware 1,188 with the exact same problem. ABS not working and throwing C1805 and U1900. I wrote to tech support about it yesterday.

any update here?

none that i know of and last info from tomaszc was same......

What settings did you use ? Just tryed to get my rx8 to work but dash is not working, also the black is showing can fault.