no sync, no spark

oliverthomsen · Post by **oliverthomsen** » Mon Apr 18, 2016 9:30 pm

i have an rb25 det engine with 36-1 trigger wheel.
when i try to start the engine i can se my rpm is about 140.
my ignition angle is 10 degres.
but i have no sync, no spark, and no injector reaction.

i am using VAG coils.
coils type: coils with built in amplifier.

sensor type: vr sensor
trigger type: with one missing tooth
trigger edge: falling
num teeth: 36
first trigger tooth: 3
trigger angle: 80

hope someone can help me.

PSI-Motor · Post by **PSI-Motor** » Mon Apr 18, 2016 10:39 pm

Please post your map and a scope.
I think it will be enough to change your settings to rising on primary trigger.

oliverthomsen · Post by **oliverthomsen** » Tue Apr 19, 2016 9:10 pm

i have a picture that shows turning the engine.

PSI-Motor · Post by **PSI-Motor** » Tue Apr 19, 2016 9:43 pm

Sorry can't see.

Go in under primary trigger and enable scope, then go to log ----- > scope -----> Crank it and press the arrow "get scope data" whilst cranking.

oliverthomsen · Post by **oliverthomsen** » Wed Apr 20, 2016 10:09 pm

Problem solved.
The Sekundery trigger type has to stay on "do not use"
Thanks so much for helping.

RHD · Post by **RHD** » Thu Apr 21, 2016 3:43 am

that will only work in waste spark configuration now

Ecumaster forum

no sync, no spark

Re: no sync, no spark

Re: no sync, no spark

Re: no sync, no spark

Re: no sync, no spark

Re: no sync, no spark