Using a Greddy Solenoid for Boost Control

All about our superior engine management unit.
Locked
ren
Posts:29
Joined:Mon May 23, 2016 11:14 pm
Re: Using a Greddy Solenoid for Boost Control

Post by ren » Sun Aug 07, 2016 11:10 pm

If it's the one from the profec-b or profec-b spec 2, then as per the manual.
Top
Welshman
Posts:101
Joined:Mon Feb 02, 2015 1:06 am

Re: Using a Greddy Solenoid for Boost Control

Post by Welshman » Mon Aug 08, 2016 2:33 pm

i use the greddy spec 2 valve , wired as per manual , atm im running 2.3 bar , dropping to 2.1 by 8k in closed loop
Top
ren
Posts:29
Joined:Mon May 23, 2016 11:14 pm

Re: Using a Greddy Solenoid for Boost Control

Post by ren » Wed Aug 10, 2016 10:31 pm

Stout. What engine/turbo is that on?
Top
Welshman
Posts:101
Joined:Mon Feb 02, 2015 1:06 am

Re: Using a Greddy Solenoid for Boost Control

Post by Welshman » Thu Aug 11, 2016 5:50 pm

3sgte pte 6266 gen 2

just dropped a piston though , would of been ok if heat compensations were set right HOT day , drag strip and big cue not so good 10.55 though .
Top
Locked

Return to “EMU STANDALONE”