VW primary trigger

[gorinycius]

Hi for everyone,how right setup this one primary trigger

[Jan32]

it is an normal 60-2 Trigger with Hall sensor.

Angle depends how it is installed on the crankshaft. Is the engine at the picture in OT?

[gorinycius]

Yes,Jan32,is on TDC.Can you write my right setup for primary trigger?(sensor i mark in white)

[PSI-Motor]

Use timing light!

[Jan32]

It should be this setting:

first trigger tooth maybe +1 or -1 means 5 or 3. Please check the ignition angle with timing light to be sure.

[gorinycius]

Thanks for replay,Jan32.This weekend try start my project

[Paulo11]

It should be this setting:

first trigger tooth maybe +1 or -1 means 5 or 3. Please check the ignition angle with timing light to be sure.Trigger.PNG

I think this isn´t good setting, because teeth are counted from opposite side.
So, the correct setting for me is: First trigger tooth- 33(+-1), rest is good.

Or am I wrong ?

[Jan32]

Paulo, sorry you are wrong

Trigger wheel is located at clutch side and goes ccw direction!

[Paulo11]

I don´t know that the trigger are on clutch side