2jzge vvti cam map

[Gonis]

General section is flooded with bots, so I will write here:
I have EMU Classic on IS300. I got acceptable fuel and ignition maps, but I have no idea how vvti map should look like. Engine is almost stock, so Im searching for factory stock vvti map (if there is any).
I attached my curent vvti map, but I feel that on low rpms it hasnt as much torque as with factory ecu. So maybe anyone can give some tips what could be ajusted there?
Thanks in advance.

[maKe]

Here is mine. Need to verify it on dyno as it seems to be hard to road tune vvti. I can only watch how the lambda starts to read lean when dialing more advance, and so does torque increase the same time. I have BC 272 cams with fully built head and 63mm BorgWarner turbo so a bit different setup compared to yours.