EMU BLACK information

[turbofreak]

How much amperage can either of the 5 volt regulators supply?

[Jadzwin]

500mA is safe value

[Ort]

I have a few questions about how to go with the harness first time that I do this,

1-What I'm gathering is that Pins B29 B38 B39 are sensors grounds and I should ground all my sensor to this 3 pins

2-The power to the sensors come from the fuse box
Example E85 one pin is 12v from the fuse box, the other is ground so that can go to the emu black B29 and the signal to B9 on the emu black

3- the only time you don't get the power from the fuse box is when it is 5v from the ecu
Example Q45 TPS it has a 5v ref that can come from B26 the input to the ecu goes to B18 and I can use the same ground B29 and is there a fuse anywhere between the ecu and the TPS sensor

[Mikekrus]

Does the ecu have a built in barro sensor as well? To adjust fuel based on elevation / altitude?

The stock Audi EGTs use a 5V signal is there anyway to wire those into the ecu?

[PSI-Motor]

Yes.
No.

[RasPL]

Hi,
Can someone explain in details how definied CAN stream is working ? I can set ID, DLC. baudrate i supose is taken from interface configuration site.

Now i can set type Rx or Tx. Rx is very small section.
At TX data how can i choice correctly parameters ? Is too much and from where should i know the selected parameter bit/byte width etc?

Can you add more parameters to the Rx ? Virtual inputs, boost blend etc. I can make own modules and i bought black because of can support.

[Zazzn]

Is there any way to alert for software updates?

[MoneypitKA24DET]

Quick question what is a safe amperage 12volt power for the ECU?

[Karel]

[MoneypitKA24DET]

If you are going to try to ridicule someone or talk down to them try switching on some spell check?