Problems after firmwire upgrade

[Flemme]

Hello

After upgrade of firmwire, my 2jz will not start... It was starting perfect before upgrade..
First i downloaded the new version of software from the website, and then i upgraded the firmwire on the ecu..

Can you check if there is anything in my map i have done wrong?

I got this message after upgrade:

"Loading project warning log.
Error: Cannot find table boostDCTable in current project. Skipped.
Error: Cannot find table etcOpenOverRevs in current project. Skipped."

Can it have some influence ??

[Jadzwin]

For what firmware version did you upgrade ? And from what version ?

[Flemme]

For what firmware version did you upgrade ? And from what version ?

1,016 before to 1,100 now

My software is 1,100 on my pc.. Cant remember last version...

[Flemme]

Can it maybe have something to do with Knock Sensor?

[Jadzwin]

PLease send us your map and the log file to tech(@)ecumaster.com

[Flemme]

PLease send us your map and the log file to tech(@)ecumaster.com

Email sent!

[Jadzwin]

Hi!

For 2JZ VVTi we changed the CAM decoder to improve engine start.
Here is a document how to setup trigger and VVTI
https://dl.dropboxusercontent.com/u/286 ... e_vvti.pdf

If you have any issues please let me know.

[Flemme]

Hi!

For 2JZ VVTi we changed the CAM decoder to improve engine start.
Here is a document how to setup trigger and VVTI
https://dl.dropboxusercontent.com/u/286 ... e_vvti.pdf

If you have any issues please let me know.

Thx ! I will try my best