s50b32 cam sync problem

[mmt]

hi
i have s50b32 turbo non vanos ,i used for intake tothwhel of s50b30(exhaust) and   jadzvin advised me
remove three teeth,and use misingtoth

Tried here as the Hall sensor,as well as VR, But I still have the same problem
the engine is not running well, so when you add gas misfires!!!
Any ideas

THX

[Jadzwin]

Please attach the log and project file

[mmt]

Please attach the log and project file

[mmt]

Please attach the log and project file

[Jadzwin]

Looks like signal noise from cam sensor.
You can try 2 missing tooth decoder.
Hoever I think the only solution is to disable cam sensor over 600-700 RPM

[mmt]

Looks like signal noise from cam sensor.
You can try 2 missing tooth decoder.
Hoever I think the only solution is to disable cam sensor over 600-700 RPM

tried HALL sensors connected here, and VR
but interference with VR was smaller

trigger type I tried them all, but either did not start or still the same problem

Tomorrow I'll try to disable cam senzor
thanks

[Jadzwin]

Actually to fully diagnose the problem you need to use scope and check the signal shape, noise and so one.

[mmt]

Actually to fully diagnose the problem you need to use scope and check the signal shape, noise and so one.

do not oscyloskop available
I have to ask a friend to help me

The fastest solution for me is to try to disable the cam sensor,for now

[PSI-Motor]

I used the standard VR Sensor with Hall and pullup settings. Works perfect. Do you use a sheilded cable all the way?
If you are not planing on running Vanos you can just disable it över 600rpm.

[mmt]

I used the standard VR Sensor with Hall and pullup settings. Works perfect. Do you use a sheilded cable all the way?
If you are not planing on running Vanos you can just disable it över 600rpm.

thanks
yes I used bmw oem cable from vr sensor , with shielding
I plan to use without vanos