Subaru STI 2004 avcs cam settings

[roquete]

Hi there, hope you guys can help me out with this 2004 Subaru Sti JDM specs with avcs and 3 cam sensors and emu black.
- I have wired the sensors as per manual with cam advance sensor for left cam on VSS and right cam to cam#2.
- engine starts and runs, needs much more tuning but i came across this problem so firstly trying to solve it.
- problem is i put cam offset to something like 178 to get the 0 degrees in the log, it stays that way but after i turn off ignition and start again i see something like -58 degrees in log and i have to go again to cam offset and up the value to something like 260, then again shut off the engine and on its again out of the 0 degree, again i have to put 178 in cam offset.
- i send the log, project and scope, i think it has something to do with min and max tooth in cam#2 setting but i cannot count the number of tooth as the primary trigger scope it does not apear the first tooth or any blank space (why is that too?).

tanks

[roquete]

Solved, hbrige outputs should not be used for cam solenoids, it outputs positive 12v when going high.