ecu voltage dropping

All about our superior engine management unit.
Locked
scottc1088
Posts:10
Joined:Sun Jan 25, 2015 11:30 pm
ecu voltage dropping

Post by scottc1088 » Thu May 14, 2015 11:00 am

I have a emu installed in my Nissan skyline on a turbocharged 1uzfe engine which I am having problems with the ecu voltage fluctuating
iv just fitted Honda k20 coils in favour of the twin distributor setup and have noticed the problem, im not 100% sure if it was there before fitting the coils but I don't think it was
battery voltage is stable as is the 12v feed to the ecu

any ideas what the problem could be?

WHPZach
Posts:184
Joined:Tue Oct 07, 2014 11:13 pm

Re: ecu voltage dropping

Post by WHPZach » Thu May 14, 2015 4:31 pm

Post up a log or a screenshot of the behavior you're describing and tell us exactly how the ECU is grounded (which wires go where, etc.).

scottc1088
Posts:10
Joined:Sun Jan 25, 2015 11:30 pm

Re: ecu voltage dropping

Post by scottc1088 » Thu May 14, 2015 6:08 pm

file posted
sure all earths are to engine block with sensor ground going to ecu
will check soon
Attachments
batt volt drop.emulog
batt olt
(171.36KiB)Downloaded 47 times

scottc1088
Posts:10
Joined:Sun Jan 25, 2015 11:30 pm

Re: ecu voltage dropping

Post by scottc1088 » Mon May 18, 2015 10:05 pm

all earths go to engine block, any other ideas?

User avatar
Jan32
Posts:191
Joined:Fri Aug 15, 2014 11:27 pm
Location:NW Germany

Re: ecu voltage dropping

Post by Jan32 » Tue May 19, 2015 9:08 am

Did you have also an bigger ground connection from the grond point at the engineblock to ground at battery?
Best regards,
Jan

Locked