All about our superior engine management unit.
-
PSI-Motor - Posts:455
- Joined:Fri Aug 15, 2014 10:57 pm
Re: Innovate MTX-L to EMU
Post
by PSI-Motor » Wed Sep 09, 2015 12:00 pm
Silas wrote:Hi
I already have a Inno Wideband Controller installed.
Back of the Gauge there are two Datalog Wires (0V-5V) and (1.1V - .1V)
So should i connect the yellow wire of the Innovate (0-5V) direkt to any Analog Input of the EMU?
So i dont Need to connect the lsu4.2 direct to the EMU?
Regards
Patrick
Use yellow wire
EcuMaster Sweden
-
Jadzwin
- Site Admin
- Posts:1445
- Joined:Tue Aug 12, 2014 11:27 pm
Post
by Jadzwin » Thu Sep 10, 2015 1:19 am
Any free one. In Oxygen sensor parameters you can select analog input.
-
ktsirigotakis
- Posts:66
- Joined:Sat Aug 16, 2014 8:39 am
Post
by ktsirigotakis » Thu Sep 10, 2015 1:14 pm
you have to set also the parameters to work correct see the pic of a friends cars
- Attachments
-
